||||| Siemens C25
Unlocking ||||
Unlock info for SIEMENS C25 v46
For this procedure you need :
- Siemens
C25_4303 Flasher
- Siemens C25_4608 Flasher
* (optionally) Siemens
ALL25.EXE service Software
1. Connect the phone to cables (phone is OFF)
2. Start the C25_4608.exe Flasher
3. Keep Pressing POWER ON button
until Flasher connects to phone
4. Flasher will start Erasing Flash
Memory
5. When it erase Flash, and start "Transmitting data to phone ..."
Disconnect the cable from the phone.
6. Phone is Dead now, and it's ok.
Dont worry.
7. Pull the battery out and put it back to phone
8. Start
the C25_4303 Flasher
9. Keep Pressing Power ON button untill it connects
to phone this takes some time .. dont be afraid, everything is OK.
10. If
Flasher displays "Could not contact the mobile ... continue ?" Press YES
11. After this, the Flasher wil start flashing
12. When It finishes, power
ON the phone
13. The phone must start normally.
14. Then Insert ANY
SIM Card ... phone is UNLOCKED
This Method saves even the phones with "WRONG
SOFTW." message.
If the whole procedure doesnt work (phone still
displays "wrong sw." here's what you need to do :
1. Flash the Phone with C25_4608 Flasher
2.
Destroy it with old C25 Unlocker (attached)
3. Start ALL25.EXE , enter
Phone's IMEI
4. Before Entering Last IMEI digit, prepare to turn the phone
ON
5. Enter last digit, turn ON the phone
6. When it comes to 21st.
step, HOLD ALT+X to exit the program (if you dont exit it's bad
7. Repeat
the procedure, and phone should display "Service mode"
8. Repat procedure
Until it says "Wrong Softw."
9. After that .... repeat procedure with
Flasher's 4608 and 4303
This, Second Procedure must be used in only 2%
of cases ....
BUT, The whole PROCEDURE (1+2) 100% Unlocks and
Repairs EVERY PHONE
 info@aussie-ringtones.com
|
